LP01-V (1000 W) 
LP03-V (3000 W)

LP05-V (5000 W)
LP10-V (10.000 W)

LP05-H (5 kW)  
LP10-H (10 kW) 
LP20-H (20 kW)

LP30-H (30 kW)
LP50-H (50 kW)
LP100-H (100k W)

Controller

Touch Screen PLC, Remote Monitoring

safety

Mechanical Pitch Contro, Active Yaw Contro, Spindle Hydraulic Brakes. Rotor Safe Lock, UPS for Power Loss

Mechanical Pitch Control:

LisePro intelligent pitch control, can change the blade angle to output more power at low wind speed and stable power output at high wind speed. It will protect the wind turbine from excessive wind.

Speed, over speed and other faults. All pitch control parts in LisePro are mechanical parts without hub, electronic parts. This is more reliable than traditional electronic pitch control system.

Active Yaw Control:

Active yaw control system will provide automatic tracking of wind turbine. Automatic deviation from wind direction when wind direction and automatic deviation

It is necessary to protect wind turbine over wind speed or other faults. It may protect wind turbine even if pitch control system fails.

Two Shaft Hydraulic Brakes:

There are two shaft hydraulic brakes for LisePro-H 20kw wind turbine. They are driven by high quality hydraulic station. They can stop wind turbine in any emergency even without pitch control, protection and yaw control protection.

Rotor Safe Lock:

It is a mechanical solution to lock rotor without electricity or hydraulic. brake, especially for wind turbine installation and maintenance or long-term stop operation.

Low RPM and Direct Drive Generator:

LisePro 100kW is a direct drive permanent magnet generator without gear. It is more reliable and requires less maintenance. induction generator. We use low rpm and larger generator diameter design. This means higher costs, but better performance in power generation, reliability and overheating problem.

Direct Connection Design:

The hub is directly connected to the generator shaft. The generator is directly connected to the nacelle. The generator shaft is directly connected to the brake disc. The optimized design for LisePro has eliminated the traditional adapter flanges and welding parts. This makes the wind turbine more reliable and more safety.

Larger Rotor and More Power Output:

LisePro-H 100kW has a rotor diameter of 24.5m, which is the same. Even larger than some 100kw wind turbines. It will reach 100kW output at 8m/s wind speed and has more power output in low wind speed area. Annual power output is about 45.6 MWh at 8 m/s wind speed.

IEC 61400-2 Casting Parts:

LisePro-H 100kW hub and nacelle are all casting parts, followed by IEC 61400-2 standard. Nacelle and hub are made by EN-GJS-400-LT MW wind turbines, which have the same material and technology as EN-GJS-400-LT. Lifetime design is more than 27 years, and can work in -20℃ to 50℃. More reliable than welding hub and nacelle.

Low Maintenance Cost:

There is automatic grease lubricator in nacelle. Automatically lubricate yaw bearing, pitch control bearing and other bearings. People could access the nacelle from inside the tower.

The LisPro-H-100 kW wind turbine will operate with a POWER Converter 100kW grid on inverter with CEI 0-21 certification for connection to the public grid.

LisePro-H 100kW wind turbine inverters can be paired with 2 BNWG-50KS grid. LisePro and Inverter engineers have done a lot of work in-house and on-site to ensure the perfect match of the system.

Bingül sok. no 7 - 34500 Büyükçekmece-Istanbul
+90 212 863 2230 - info@lisepro.com